Complete and Continue
7-Day Workshop:) Mass and Heat Balance of Pyro Section
Day 0. Introduction call.
Introduction call about Mass and Heat Balance.
DAY 0: 10-Step-formula for Mass and Heat Balance.
10-Steps as activities involved in mass and heat balance of Pyro Section (28:28)
DAY 1: Detailed Mass Balance Calculations
Kiln feed to clinker ratio calculation (11:01)
Gas and air density calculation (7:53)
Gas/Air Flow Calculations (15:41)
DAY 2: Detailed Heat Balance Calculations
Sensible Heat Calculations (10:10)
Calorific Heat Calculation (8:55)
Theoretical Heat of Clinker Formation (5:06)
Drying and Evaporation Heat Calculation (4:43)
Heat due to Non- Carbonatic (7:07)
Radiation and Convection Heat Loss Calculations (15:11)
Day 3: Process Measurements for Pyro Detailed Mass and Heat Balance.
Process measurements activity, Log sheet Templates and measurement set.
Day 4: ASSIGNMENT 1-Detailed Mass and Heat Balance.
ASSIGNMENT 1.1 for Day 2&3:)Pyro detailed mass and heat balance
ASSIGNMENT 1.2 for Day 2&3:)Cooler detailed mass and heat balance
DAY 5 :) Preliminary mass and heat balance
Identification of material streams to be calculated for Preliminary Mass and heat balance (8:39)
Calculations of material streams in case you have detailed fuel analysis (16:59)
Calculations of material streams in case you do not have detailed fuel analysis (7:12)
Day 6: ASSIGNMENT 2. Preliminary Mass and Heat Balance.
CCR Data/Measured Data required for Mass and Heat Balance
ASSIGNMENT 2.1 for Day 5:)Pyro preliminary mass and heat balance
ASSIGNMENT 2.2 for Day 5:)Cooler preliminary mass and heat balance
DAY 7 :)-Workshop take-away discussion and Q&A Session
Bonus Template to Generate Professional quality Mass and Heat Balance
Workshop take-away discussion and Q&A Session
Lecture content locked
If you're already enrolled,
you'll need to login
Enroll in Course to Unlock